Installing on Shoptet
On Shoptet the Conseto script goes into the header of your store. The app shows you the exact place and the ready code.
What it is
On Shoptet it is the same script as everywhere else. Only the place differs: you paste it into the Záhlavie (Header) section of the HTML code editor. You find the script itself in the app, and the general description is at /docs/install.
When to use it
When your store runs on Shoptet and you want to measure visits and show the consent banner. If you pick Shoptet in the first setup, the app shows you this guide first.
How to do it in the app
- Open This project and the Installation tab.
- In the Where your site runs block pick Shoptet.
- Click Copy the script.
- In the Shoptet admin open
Vzhľad a obsah(Appearance and content), thenEditorandHTML kód(HTML code). - Paste the script into the
Záhlavie(Header) section, which Shoptet places before the closing</head>tag, and save. - Open your store in a browser and see whether the app says the script is running.
What you will see
Once the store loads, the measurement status in the app changes to Collecting data. If you want purchases, use the step Measure purchases too: we have not yet checked whether Shoptet sends purchases to the dataLayer.
How to verify the installation step by step: /docs/verify-install.
Common problems
- The script is in the body of the page or in a section other than the header. Move it and save.
- You pasted it twice. Keep one copy.
- The change has not shown yet. Reload your store without the cache (a hard refresh) and try again.
Read next
Checked against the code on 20 November 2026.
Missing something?
This is everything we document today, and each page says only what the script and the gateway do now. If you need a guide that is not here, tell us what you want to achieve.
Write to us